Dell Compellent Series 30 - Manual (Page 34)

28 Storage Center System Setup Guide
Setting Up the Storage Center
3 Your next action depends upon the following:
• If there are no warnings for any transport type and there is only one Fibre Channel
switch fabric, click Continue to proceed to
Step 13: Generate SSL Certificate on
page 43 .
• If there are no warnings for any transport type and there are two Fibre Channel
switch fabrics, you must select Configure Local Ports and create a new Fault
Domain. Follow your pre-installation documentation for site-specific connections.
Make sure that controller ports physically connected to fabric 1 are in one Fault
Domain and controller ports connected to fabric 2 are in another Fault Domain.
Proceed to
Configuring Legacy Mode Local Ports – iSCSI, FC, and SAS on page 28 .
• If there are warnings for any transport type, click Configure Local Ports to modify
the configuration and correct any issues that cause warnings. Proceed to
Configuring Legacy Mode Local Ports – iSCSI, FC, and SAS on page 28 .
Configuring Legacy Mode Local Ports – iSCSI, FC, and SAS
You modify local port configuration settings for all transport types by using the dropdown
menus and buttons that appear on the Configure Ports dialog. The following example
uses an iSCSI local port.
1 Click the iSCSI tab to select the Configure Ports dialog for iSCSI.
Figure 22. Configure Local Ports (iSCSI)
2 Use the dropdown menus and buttons to open dialogs that enable you to edit fault
domains.