Dell XPS 700 Jet Black - Manual (Page 110)

112
Removing and Installing Parts
6 Replace the drive panel (see "Replacing the Drive Panel" on page 105).
7 Replace the computer cover (see "Replacing the Computer Cover" on page 125).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
8 Connect the computer and devices to electrical outlets, and turn them on.
Installing a Media Card Reader
1 Follow the procedures in "Before You Begin" on page 75.
2 Remove the computer cover (see "Removing the Computer Cover" on page 76).
3 Remove the drive panel (see "Removing the Drive Panel" on page 104).
4 Remove the existing media card reader, if applicable (see "Removing a Media Card Reader" on
page 110).
5 If no screws are attached to the Media Car d Reader, check the inside of the drive panel for shoulder
screws. If screws are present, attach the screws to the new card reader.
1 drive release latch 2 media card reader
1
2
book.book Page 112 Thursday, July 20, 2006 11:10 AM