Dell XPS 700 Jet Black - Manual (Page 99)

Removing and Installing Parts
101
5 Ensure that all connectors are properly cabled and firmly seated.
6 Replace the computer cover (see "Replacing the Computer Cover" on page 125).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7 Connect the computer and devices to electrical outlets, and turn them on.
Installing a Hard Drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
1 Follow the procedures in "Before You Begin" on page 75.
2 Remove the computer cover (see "Removing the Computer Cover" on page 76).
3 Remove the existing hard drive, if applicable (see "Removing a Hard Drive" on page 99).
NOTE:
If a hard-drive bracket is installed inside of the hard-drive bay, remove the bracket before you install
the new hard drive.
1 blue tabs (2) 2 hard drive 3 hard drive bay
1
3
2
book.book Page 101 Thursday, July 20, 2006 11:10 AM