Dell XPS 700 Jet Black - Manual (Page 118)

120
Removing and Installing Parts
Installing the Processor Airflow Shroud
1 Follow the procedures in "Before You Begin" on page 75.
2 Remove the computer cover (see "Removing the Computer Cover" on page 76).
3 Align the hinge slots on the processor airflow shroud with the hinge guides on the system board.
4 Gently rotate the processor airflow shroud towards the fan, and then tighten the two captive screws.
5 Close the computer cover (see "Replacing the Computer Cover" on page 125).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
6 Connect your computer and devices to electrical outlets, and turn them on.
Processor
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and replacement.
Performing these steps incorrectly could damage your system board. For technical service, see "Dell Technical
Support Policy (U.S. Only)" on page 142.
Removing the Processor
1 Follow the procedures in "Before You Begin" on page 75.
2 Remove the computer cover (see "Removing the Computer Cover" on page 76).
3 Disconnect the power cables from the POWER1 and POWER2 connectors (see "System Board
Components" on page 79) on the system board.
4 Remove the airflow shroud (see "Removing the Processor Airflow Shroud" on page 119).
5 Push down and out on the socket release lever.
book.book Page 120 Thursday, July 20, 2006 11:10 AM