Dell XPS 700 Jet Black - Manual (Page 82)

84
Removing and Installing Parts
6 Replace the computer cover (see "Replacing the Computer Cover" on page 125).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7 Connect your computer and devices to electrical outlets, and turn them on.
8 When the message appears stating that memory size has changed, press <F1> to continue.
9 Log on to your computer.
10 Right-click the My Computer icon on your Windows desktop and click Properties.
11 Click the General tab.
12 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE:
To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 75.
2 Press out the securing clip at each end of the memory module connector.
3 Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the
connector.
book.book Page 84 Thursday, July 20, 2006 11:10 AM