Every 100 hours, Engine oil, Changing the engine oil – Cub Cadet SC2400 User Manual
Page 101: Every 100 hours -23, Engine oil -23, Changing the engine oil -23, Warning
14-23
Sc2400 Operator’s Manual
■ Engine Oil
Use an oil of the viscosity appropriate for the air
temperature range expected until the next oil change
interval.
Engine crankcase
■ Changing the Engine Oil
●When draining away the engine oil that is still
hot, stay clear of the hot engine oil and other
components to avoid burn.
IMPORTANT: Avoid damage.
Change the engine oil more frequently if the tractor is
used in extremely demanding conditions:
●Extremely dusty conditions
●Frequent slow- or low-speed operation
●Frequent short trips
1. Run the engine to warm up the engine oil.
2. Park the tractor safely on a level surface.
3. Open the hood.
4. Place an engine oil pan beneath the engine oil
drain plug.
(A) Drain plug
5. Remove the drain plug by turning
counterclockwise.
6. Reinstall the drain plug. Do not over-tighten it.
7. Remove the oil fill cap.
8. Add approximately 2.5 US qt (2.4 L) of the engine
oil.
9. Reinstall the oil fill cap.
10.Start and idle the engine to check for any leaks.
11.If there is any leakage, stop the engine, close the
hood and contact your local Cub Cadet Yanmar
for technical assistance.
12.Check the engine oil level and add more as
necessary.
13.Close the hood.
5. Every 100 Hours
Capacities
Lubricants
Approximately
2.5 US qt (2.4 L)
API Service Classifications
CF or higher
SAE 10W-30 or SAE 10W-40
WARNING
3013738
The following oils are recommended:
(A)
P3014926