Cub Cadet SC2400 - Manual (Page 50)

8-8
8. OPERATING THE TRACTOR
Sc2400 Operator’s Manual
1. Slowly remove foot from the forward
side of the forward and reverse drive
pedal or reverse side of the forward
and reverse drive pedal.
2. Fully push the throttle control lever
forward to decrease the engine
speed.
3. Step on and depress the brake pedal.
4. After the tractor has completely
stopped, turn off the Power Take Off
(PTO) switch.
5. Lower the implement (if equipped) to
the ground.
6. Engage the parking brake securely.
7. Run the engine at a lowest possible
speed for at least for two minutes.
8. Turn the key to the OFF position.
9. Remove the key from the starter key
switch.
10.Make sure that the engine and other
rotating component(s) have stopped
running. NEVER leave the operator’s
seat while any component is running.
(A) Forward and reverse drive pedal
(B) Throttle control lever
(C) Power Take Off (PTO) switch
■ Emergency Stop Procedure
1. Remove foot from the forward side of the forward
and reverse drive pedal or reverse side of the
forward and reverse drive pedal.
2. Depress the brake pedal.
3. Turn the key to the OFF position.
4. Keep the brake pedal pressed until all the moving
parts on the tractor come to a full stop.
5. Engage the parking brake securely.
3. Stopping Travel of the Tractor
3013703a
(B)
(A)
3014919b
(C)