Cub Cadet SC2400 - Manual (Page 108)

14-30
14. PERIODIC SERVICE
Sc2400 Operator’s Manual
■ Front Axle Case Oil
IMPORTANT:
●Make sure to use Cub Cadet GEAR LUBE or SAE
80W-90 gear oil for front axle case oil.
Front Axle Case Oil
■ Changing the Front Axle Case Oil
Avoid injury:
●When draining away the front axle case oil that
is still hot, stay clear of the hot transmission oil
and other components to avoid burn.
1. Operate the tractor to warm up the front axle case
oil.
2. Park the tractor safely.
NOTE:
●The front axle case contains approximately 2.6 US
qt (2.5 L) of oil.
●Be sure to change the oil in both right and left front
axles.
3. Place drain pans underneath the axle drain plugs
on both sides of the front axle.
4. Remove the axle drain plugs and allow the oil to
fully drain.
5. Make sure that the oil has fully drained. Dispose
of waste properly. Reinstall and tighten the drain
plugs.
6. Remove the dipstick located on the right side of
the front axle.
7. Add Cub Cadet GEAR LUBE or SAE 80W-90
gear oil through the fill port to the specified level.
8. Reinstall and tighten the dipstick.
9. Check the front axle case oil level again.
IMPORTANT: Avoid damage.
●Before checking the oil level, allow the oil to settle
for 1 hour so that the current oil level can be
accurately checked on the dipstick. Recheck the oil
level after operating the tractor for several hours.
10.Again, check the axle case oil level.
(A) Axle drain plugs
(B) Dipstick
8. Every 500 Hours
Capacities Lubricants
Approximately 2.6 US qt
(2.5 L)
Cub Cadet GEAR LUBE
or SAE 80W-90 gear oil
WARNING
(A)
3014922
(B)