Qmark WPC1500 - Portable Panel Heater - Manual (Page 3)

on the front panel of your heater. When the red light illuminates,
it signifies that the safety thermal cutout is in operation. This
safety device automatically shuts off your heater in the event of
overheating. Do not continue to use heater if it repeatedly cycles
OFF and ON due to over-temperature. Should the unit overheat
and activate the thermal cutout cycle, the cause of the overheat-
ing should be determined before further operation by a qualified
electrician to determine the problem. MAINTENANCE INSTRUCTIONS
ClEANING
Turn thermostat off. Disconnect electrical power before cleaning
heater.
Use a soft cloth for dusting. For cleaning use only a damp rag
and nonabrasive dish detergent. Do not use abrasive or chemi-
cal cleaners as these may harm the finish.
If heater is used in a very dusty location, use a vacuum cleaner
dust brush to remove dust and other foreign material from the
grilles.
Always unplug heater when not in use. When heater is not to be
used for an extended period of time, cord should be coiled and
tied to prevent damage and heater should be stored in a safe
location.
L1
N1 N2
L2
Limit
Warning
Light
Power
Light
Power
Switch
Switch
A
1 2
Thermostat
Terminal
Block
Tip Over
Switch
Ground
Plug
Element
Figure 5 - Wiring diagram
1
2
Replacement Parts list
1 Knob 3301-2058-000 1
2 Wheel Kit 1205-10305-000 1
(Contains 2 legs with 4 wheels)
Reference
Number
description Part Number: Quantity