Two Brothers Racing Can-Am Spyder Outlander MAX 800R User Manual

V.a.l.e, Juice box™ - fuel controller

Advertising
background image

Two Brothers Racing

Juice Box™ - Fuel Controller

2009 Can-Am Outlander 800R Installation & Operation Manual

Part # 008-255

Installation Instructions

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

8. NOTE: Re check your wire routing and JUICE BOX™

location and make certain that in no way the wires can

come into contact with any moving parts or high heat

source and that the JUICE BOX™ is mounted in a way as

to not cause a handling problem with the machine.

9. Reassembly is opposite of disassembly.

Thank you for purchasing a genuine Two Brothers Racing

JUICE BOX™. This product represents a radical step

forward in tuning fuel-injected motorcycles and ATVs for

optimal performance using “load-based” technology.

We at Two Brothers Racing hope that you will find this

development as exciting and useful as we do. And

remember: Proper Fuel = Maximum Power!

1. Make sure the vehicle is completely cool before starting

the installation. Also, make sure the vehicle is secure and

will not roll around.

2. Remove the rear and front seat.

3. Remove right side cover by pulling off.

4. Locate and disconnect front and rear injectors.

5. Attach the JUICE BOX™ to frame in front of front seat.

6. Route JUICE BOX™ harness to injectors and attach.

Attach ground Led to under seat heat shield.

7. Start the ATV. The green LED should scroll left to right

and back for about 3-5 seconds and then go to 1 or more

steady or slowly flashing green LED’s. If the number 1

green LED AND number 8 red LED’s continue flashing

after startup or idling, an injector wiring error is indicated.

Re-check the wires from the JUICE BOX™ and make sure

they are connected to the proper wire of your ATV’s stock

harness. MAKE SURE you have the correct wires selected

in the stock harness. DO NOT PROCEED UNLESS ABOVE

CONDITIONS ARE MET.

Continued on page 2

Parts Incuded

Qty.

Description

Part Number

1

Juice Box™ Fuel Control Kit

008-255

(#9320093)

3

Zip Ties

1

Adhesive Velcro Square

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original

defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers

racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.

to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of

original purchase.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions

first before starting installation. Make sure the vehicle and exhaust system are

completely cool before starting the installation. Also, make sure the vehicle is

secure during installation. Be sure to save all stock components for possible use

later.

The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is

not applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway

or off-road vehicles. The Juice Box™ is not applicable, nor inteded for use on

aircraft.

Fig 1

Fig 2

Fig 3

Advertising