Two Brothers Racing Polaris Ranger XP/RZR800 - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2008 Polaris Ranger RZR800 Installation & Operation Manual
Part # 008-185
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-185
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Unplug the OEM connectors and plug in the JUICE BOX™
connectors in place of the current wires as shown (Fig. 4).
The Two Brothers Racing Crew recommends attaching
the JUICE BOX™ to the back of the shifter case using
the velcro square provided. Then routing the wire plugs
down through one of the holes in the frame between
the seats. We also used the zip ties provided to keep the
wires together once connected (See Fig. 5a, 5b).
Connect the ground wire to ground connector on the
battery (Fig. 6).
NOTE: Re-check your wire routing and JUICE BOX™
location and make certain that in no way the wires can
come into contact with any moving parts or high heat
source and that the JUICE BOX™ is mounted in a way as
to not cause a handling problem with the machine.
5.
6.
7.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified ATV technician. If
you have any doubts as to your ability to install this performance part, please consult
with your local ATV dealer. Read all instructions first before starting installation. Make
sure the vehicle and exhaust system are completely cool before starting the installation.
Also, make sure the vehicle is secure during installation. Be sure to save all stock
components for possible use later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove both the driver’s seat and the passenger seat
by pulling up the latch at the rear of each seat base (See
Fig.1).
Remove the plastic engine cover (Fig. 2a, 2b).
Locate the fuel injector plugs at the rear of the driver’s
seat location (Fig. 3).
1.
2.
3.
4.
Fig 1
Continued on page 2
Fig 2a
Fig 2b
Fig 3
Fig 4
Fig 5a
Fig 5b
Fig 6