Two Brothers Racing Can-Am Spyder Spyder - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2008 BRP Can-Am Spyder Installation & Operation Manual
Part # 008-229
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-229 (#9120210)
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Remove rear injector connector from right-side of
machine. (fig.5)
Remove front injector connector from left-side of
machine. (fig.6)
Injector connector looks just like connectors supplied on
JUICE BOX™. Compress metal spring clip to remove.
Run JUICE BOX™wires as shown in figure 7.
Plug JUICE BOX™into OEM O2 Sensor harness located
under rear tail section as shown in figure 8.
Attach ground wire to a suitable ground. (fig.9)
6.
7.
8.
9.
10.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove the left and right knee covers. (fig.1)
Remove the 7 screws securing the undertail. (fig.2)
Raise seat. (fig.3)
Remove the left and right engine shroud. (fig.4)
1.
2.
3.
4.
5.
Continued on page 2
Fig 1
Fig 5
Fig 2
Fig 3
Fig 4
Fig 6
Fig 7
Fig 8
Fig 9