Two Brothers Racing Honda CBR1000RR (2008) - CA Emissions Legal User Manual

V.a.l.e, Juice box™ - fuel controller

Advertising
background image

Two Brothers Racing

Juice Box™ - Fuel Controller

2008 Honda CBR1000RR Installation & Operation Manual

Part # 008-206C

Parts Incuded

Installation Instructions

Qty.

Description

Part Number

1

Juice Box™ Fuel Control Kit

008-206C

(#9140054C)

3

Zip Ties

1

Adhesive Velcro Square

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Remove the four right and left bolts that secure the tank.

Open the gas tank briefly to vent it before disconnecting

the fuel line as the tank may be under pressure. Gently

lift the tank and remove two vent lines (one small and one

large), two electrical connectors (Brown one on the left

and Black one on the right) and the quick disconnect fuel

line. Remove the fuel tank from the motorcycle.

(Fig 5 and 6)

Remove fabric air box cover.

Attach the adhesive backed hook and loop material to the

back of the JUICE BOX™ and the front left cockpit fairing

next to the instrument cluster. (Fig 7)

Route the JUICE BOX™ harness between the steering

stem and the left fork tube, over the air box and down

into the engine compartment to the LOWER fuel injection

rail. Zip-tie the harness as shown. (Fig 8)

5.

6.

7.

8.

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original

defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers

racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.

to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of

original purchase.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance part,

please consult with your local motorcycle dealer. Read all instructions first before

starting installation. Make sure the vehicle and exhaust system are completely cool

before starting the installation. Also, make sure the vehicle is secure during installation.

Be sure to save all stock components for possible use later.

This Juice Box is legal for use on Emissions Controlled street and highway vehicles.

The Juice Box™ is not applicable, nor inteded for use on aircraft.

Thank you for purchasing a genuine Two Brothers Racing

JUICE BOX™. This product represents a radical step

forward in tuning fuel-injected motorcycles and ATVs for

optimal performance using “load-based” technology.

We at Two Brothers Racing hope that you will find this

development as exciting and useful as we do. And

remember: Proper Fuel = Maximum Power!

Make sure the vehicle is completely cool before starting

the installation. Also, make sure the vehicle is secure and

will not roll around.

Remove the right and left sub-frame side panels by gently

pulling. (Fig 1)

Remove the front seat by removing right and left seat

bolts. (Fig 2)

Remove the four bolts that secure the plastic tank cover.

There are two at the front and two at the rear of the tank.

(Fig 3 and 4)

1.

2.

3.

4.

Continued on page 2

Fig 1

Fig 5

Fig 2

Fig 3

Fig 4

Fig 8

Fig 8

Fig 6

Advertising