Two Brothers Racing Kawasaki ZX-10R - Dual Flange-On - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2006-07 Kawasaki ZX-10R (for Dual Flange-on) Installation & Operation Manual
Part # 008-139F
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-139F
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Remove tail cowl mount screws. Remove RH helmet
hook. Lift tail cowl slightly and slip JUICE BOX™ between
cowl and rear frame. (Fig 5)
Lift the tail cowl and slip the JUICE BOX™ harness over
the two cowl mounts. (Fig 6)
Route and connect JUICE BOX™ ground lead. (Fig 7)
Velcro and cable tie the JUICE BOX™. (Fig 8)
NOTE: Re check your wire routing and JUICE BOX™
location and make certain that in no way the wires can
come into contact with any moving parts or high heat
source and that the JUICE BOX™ is mounted in a way as
to not cause a handling problem with the machine.
Assembly is the opposite of disassembly.
6.
7.
8.
9.
10.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove trim cover screws. Remove trim covers. (Fig 1)
Remove seat mount screws, remove seat. (Fig 2)
Remove front tank stay bolts. Lift and support tank. (Fig 3)
Locate and disconnect the brown OEM connector and
plug the JUICE BOX™ harness into the brown OEM
connectors. (Fig 4)
1.
2.
3.
4.
5.
Continued on page 2
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Fig 6
Fig 7
Fig 8