Sony MHC-F100 - Manual (Page 7)

step 3: Presetting
radio stations
For Singaporian model, you can preset up to
40 stations, 20 for FM, 10 for MW and 10 for
SW. For North and South American and
Australian models, you can preset up to 30
stations, 20 for FM and 10 for AM.
I Press TUNER/BAND repeatedly
until the band you want appears in
the display.
Every time you press this button, the
band changes as follows:
Singaporian models:
FM -* MW -► SW
t_________I
North and South American and
Australian models:
FM'H-^AM
2
Press TUNING MODE repeatedly
until "AUTO" appears.
3
Turn the jog dial.
The frequency indication changes and
scanning stops when the system tunes in
a station, "TUNED" and "STEREO" (for
a FM stereo program) appear.
FM 0 0 . 5 0 .
4
Press TUNER MEMORY.
A preset number appears in the display.
Preset number
J
- MEMORY FM
’7
5
Turn the jog dial to select the
desired preset number.
6
Press ENTER.
The station is stored.
7
Repeat steps 1 to 6 to store other
stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
"MANUAL" appears in step 2, then turn the
jog dial to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-preset to 10
kHz (9 kHz in some areas). To change the
AM tuning interval, tune in any AM station
first, then turn off the power. While holding
down the ENTER button, turn the power
back on. When you change the interval, AM
preset stations will be erased. To reset the
interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.