Regulatory information – Sony PCG-748 User Manual

Page 2

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Use caution when installing or
modifying telephone lines.
Avoid using the modem during an
electrical storm.
Do not use the modem or a telephone
to report a gas leak' in the vicinity of

the leak.
A socket outlet should be as close as
possible to the unit and ecisily
accessible.

The use of optical instruments
with this product will increase eye

hazard.

AVERITISSEMENT

Pour prévenir tout risque d’incendie

ou d’électrocution, garder cet appareil
à l’abri de la pluie et de l’humidité.
Pour prévenir tout risque
d’électrocution, ne pas ouvir le châssis
de cet appareil et ne confier son
entretien qu’à une personne qualifiée.
L’appariel doit être le plus près
possible d’une prise murale pour en
faciliter l’accès.

Regulatory Information

Declaration of Conformity

Trade Name: SONY

Model No: PCG-748

Responsible Ptirty:

Sony Electronics Inc.

Address:

1 Sony Drive

Park Ridge, NJ 07656

Telephone No.: 201-930-6970

This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful

Interference, and (2) this device
must accept any interference that
may cause undesired operation.

This equipment has been tested and found
to comply with the limits for a Class B

digital device, pursuant to Part 15 of the
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential Installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
Interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause

harmful Interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference Ijy one or more of the
following measures:

Reorient or relocate the receiving

■ antenna.

Increase the separation between the
equipment and the receiver.

Advertising