Speakers, Sound lacks bass, Cd player – Sony DHC-MDX10 User Manual
Page 86: The cd tray does not close, The cd will not play, Play does not start from the first track, Over" is displayed, The display shows a code made up of, Three letters and a message, The disc will not be inserted
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting (continued)
MD Deck
Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Check the speaker connection and
speaker placement.
Sound lacks bass.
• Check that the speaker's + and - jacks are
connected correctly.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
Play does not start from the first track.
• The player is in program or shuffle mode.
Press PLAY MODE repeatedly until
"PROGRAM" or "SHUFFLE" disappears.
"OVER" is displayed.
• You have reached the end of the CD.
Press ◄◄ to return.
The display shows a code made up of
three letters and a message
• This system has the Self-Diagnostic
function (see "Self-diagnosis Display" on
page 88).______________________________
The disc will not be inserted.
• Insert the MD in the direction of the
arrow.
The controls do not work.
• The MD is dirty or scratched. Replace the
MD with a new one.
The MD will not play.
• Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
• Nothing is recorded on the MD.
Recording is not possible.
• The MD is protected against erasure.
("Cll" and "Protected" appear
alternately.) Slide the tab to close the slot
(see page 34).
• Connect the sound source properly.
• A pre-recorded MD is in the deck.
Replace the disc with a recordable MD.
• Replace the disc with a recordable MD
that-has sufficient time remaining or erase
unnecessary tracks.
• The mains lead was unplugged or a
power interruption occurred during
recording. Start recording over from the
beginning.
"-OVER-" is displayed.
• You have reached the end of the MD.
Press ◄◄ to return to the beginning of
the MD.
"OVER" lights up during recording.
• A strong signal was input during
recording in the TAPE function. When
the sound is distorted, reduce the
recording level ("Adjusting the recording
level" on page 42), then re-record.
86