Sony MHC-331 - Manual (Page 4)

Chapter 1:
Setting
Up
Connecting the Stereo
Inserting the Batteries
Setting the Clock
Connecting the
Stereo
Use the illustrations below to connect your
stereo.
If you want to connect any optional
components to the stereo, see "Connecting
Optional Equipment" in Chapter 6.
Connecting the STEP 1
Speakers
After arranging both ends of the speaker
cables, connect all speakers to the ui\it.
Before connecting the speakers
Twist the speaker cable coating and strip it
from the end of the cable.
To connect the front speakers
Connect the right front speaker to the
SPEAKER R connectors and the left front
speaker to the SPEAKER L connectors with
the red cords to ® and the black cords to
e.
STEP 2 Connecting the
Antennas
FM lead antenna* (supplied)
* Note: Extend it horizontally
AM loop antenna connection
Cormect the supplied loop antenna to the
AM and the
rh terminals.
To improve the FM reception
Connect an external FM antenna to the
FM 750. and fh terminals, using a 75-ohm
coaxial cable.
Important
Ground the external antenna from rh
terminal against lightning with the screw
clamp. To prevent a gas explosion, do not
connect the ground wire to a gas pipe.
To improve the AM reception
After you connect the AM antenna, connect
a 6- to 15-meter (20- to 50-feet) insulated
wire to the AM terminal. Connect the
/h
terminal to earth.
Important
Ground the external antenna against
lightning from the
rh terminal. To prevent a
gas explosion, do not connect the ground
wire to a gas pipe.
(not supplied)
^ I Chapter 1: Setting Up