Sony MHC-331 - Manual (Page 6)

Inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1 Open the lid.
2
Insert two R6 (size AA) batteries.
Match the and - indications to the
diagram in the battery compartment.
3
Close the lid.
Buttery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When th^e batteries no longer operate the
remote, replace all the batteries with new
ones.
To evoid battery leekage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Setting the Clock
The built-in clock shows the time in the
display even if the power is off. You need
to set the dock to utilize the timer-activated
features of your stereo system.
Use the buttons on the unit to do this
operation.
DISPLAY/DEMO
6
Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
dock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
5
4,6
3,5
flashing
To check the time
Press DISPLAY/DEMO a few times.
The current time is displayed for eight
seconds.
To correct the clock setting
Repeat steps 1 through 6.
Press TIMER.
2
Press CLOCK SET.
The “AM" and hour indication begin
flashing.
V_* 4
-44"
flashing
3
Set the current hour by press and hold
down or ^ on MULTI
CONTROLLER until the correct hour
appears.
-4
flashing
4
Press ENTER/NEXT.
The minutes indication begins flashing.
nr,
flashing
5
Set the current minute by press and hold
down or >> on MULTI
CONTROLLER until tìre correct minute
appears.
flashing
0 I Chapter 1: Setting Up