Sony IJP-V100 - Manual (Page 29)

7 .
REQUIRED!
Ymi must install the sot'tware
bot'orc using your new Sony
IJP-V100 - if you don't, the
Sony IJP-VlOO won't work.
lmt)ortant: If you don't have
a CD-ROM dise drive, please
eall the Sony Teehnieal
Response Center 1-888-
4SONYPC at (1-888-476-
6972) to reeeive the soft­
ware on 3.5-ineh floppy
diskettes.
1. Turn on your eomputer. Or. if you did not turn ol'f your eoinputer
previously in Step .3. restart your eomputer now.
One of two things w'ill happen: Hither the “New Hardware Found"
sereen will be displayed, or just the Windows 95 desktop will be
displayed.
- •
If "New Hardware Found" is displayed:
Choose "Driver from disk provided by manufacturer." then click
OK. Insert the Sony IJP-'VlOO CD into your CD-ROM drive, or if
you have floppy disks, insert Disk #1 into your floppy drive. Make
sure the correct drive is displayed in the dialog box, for example,
“d:" for your CD-ROM drive or “a;" for your floppy drive. Click
OK. Continue at step 4 below.
3. If just the Windows® 95 desktop is displayed:
Insert the Sony IJP-V 100 CD into your CD-ROM drive, or if you
have floppy disks, insert Disk #1 into your floppy drive. If you’re
installing from the CD, the Sony IJP-V100 Welcome screen will
be displayed after a few .seconds. If you’re installing from a floppy
disk, choo.se
Run from the Start menu in Windows 95®, then type:
a:\setup.exe
where “a:” represents the letter of your floppy disk drive. Click
OK.
For .some PCs, including the Sony PCV-150 you may see the
“Update Device Driver Wizard” screen.
If the “Update Device Driver Wizard” screen appears (see page I -
24), click “Cancel” and re-insert the IJP-V 100 CD. When the
installation program appears, click “Install the Sony UP- VI00
software on your PC,” and complete the procedure.