Loading multiple envelopes, Loading transparencies – Sony IJP-V100 User Manual
Page 88
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Load a single
envelope with
the address
facing you and
the stamp-edge
down.
• Load a single envelope as
shown, with the
address-side fac
ing toward you and the stamp-
edge down.
• Change the paper size in the
print settings to the envelope size
you loaded. Refer to “Using the
Paper tab settings” later in this
chapter.
Loading multiple envelopes
Slide the right
paper guide
to the envelope
position.
Load envelopes
with the address
facing you and
the stamp-edge
down.
O
Pull the document tray for
ward and remove any paper from
the paper supply tray.
e
Pinch and slide the
right
paper guide
to the envelope
position.
o Load the stack of envelopes
(up to 10) with the
address-side
facing toward you and the
stamp-edge down.
Align the
right edge of the stack with the
right paper guide.
O Pinch and slide the
left paper
guide
until it touches the left
edge of the envelope stack.
of the envelope ^
document tray back
ward until it rests against the
paper tray.
Slide the left
paper guide
to the edge
Loading transparencies
Load the
transparencies
with the rough
side facing
you and the
adhesive-strip
edge down.
• Load transparencies (up to 50)
with the
adhesive-strip edge
down and facing away from
you^ and the rough side facing
toward you.
The arrows on the
adhesive strip will be on the side
of the transparency that faces
away from you.