Sony KW-34HD1 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the DTV System
Connect the TV
and DTV Receiver
For details on routing the cables through the stand, see page 21.
1
Route the coaxial cable from the antenna through the stand to the lower
shelf and connect it to the DTV receiver's FROM ANTENNA jack.
O You cannot receive digital channels unless you connect a terrestrial antenna. This
applies even if you normally receive your programming through cable or satellite.
2
Connect the digital I/O cable to the DTV receiver's I/O jack.
^ To ensure best picture quality, use an outdoor antenna. The use of indoor rabbit ears is not
recommended.
^ Before conneding the I/O cable, check that it is oriented as shown — with the noise filter
closer to the DTV receiver.
3
Route the other end of the digital I/O cable through the stand and connect
it to the TV's DTV I/O jack.
4
Route the TV's AC power cord through the stand and connect it to the
receiver's AC outlet.
5
Route the receiver's AC power cord through the stand. Connect this to an
AC wall outlet only after you have finished connecting all components.