About the learn function, Using the learn function – Sony KW-34HD1 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other Information
Using the Learn
Function
You can program the remote control to learn the functions of another
manufacturer's remote control. Use this function to operate equipment that is
not listed in "Programmable Codes" on page 58.
1
Set the slide switch in the inside panel to
VTR3
or
DVD/MDP.
2
Place the DTV's remote control and the other manufacturer's remote
control directly facing each other, about two inches apart.
Learning
buttons
Approx. 2 inches
3
4
Press
LEARN.
The Learn indicator lights.
Press one of the learning buttons (see illustration) on the DTV's remote
control that you want to learn a function. The Learn indicator flashes off,
then on, indicating that the DTV's remote control is now ready to learn.
Hold down the corresponding button on the other component's remote
control. When the Learn indicator flashes off, then on, release the button
on the other component's remote control.
If the indicator doesn't fla,->h, repeat steps 4 and 5.
To learn other functions, repeat steps 4 and 5.
About the Learn Function
U The Learn function does not work in the VTRl and VTR2 slide switch
positions.
□
During the learning procedure, do not move the remote controls.
□
If you press a button on this remote control that cannot be used for
learning, the Learn indicator flashes four times.
U To clear all learned signals from memory, set the slide switch inside the lid
to
DVD/MDP,
press
LEARN,
press the
TV POWER
button while holding down
the
VOL-
button, and then press
LEARN
again.
_| When you remove the batteries — to replace them, for example — any
codes you've set may be erased.