Sony MHC-RXD3 - Manual (Page 8)

To erase a preset number
1 Press and hold TUNER MEMORY until the
preset number flashes in the display.
2 Press or repeatedly to select the
preset number you want to erase.
If you want to erase all preset numbers,
select "ALL ERASE".
3 Press ENTER/NEXT.
When you erase a preset number, the total
number of preset stations decreases by one.
You can add a new preset number after the
last preset number.
To change the AM tuning interval
(for models with the AM TUNING STEP
switch on the rear panel)
The AM tuning interval is factory-preset to
9 kHz (10 kHz in some areas). To change the
AM hming interval, turn off the system and
set the AM TUNING STEP switch on the rear
panel to 10 kHz (or 9 kHz). Then turn the
system back on. When you change the
interval, all the preset stations will be erased.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
step 3: Presetting radio stations
(continued) Connecting optional
AV components
To enhance your system, you can connect
optional components. Refer to the
instructions of each component.
Connecting audio
components
Select one of the following two coimections,
depending on the equipment to be connected
and method of recording.
Connecting an MD deck for digital
recording
You can record from CD into the MD deck
digitally by connecting an ophcal cable (not
supplied).
To the DIGITAL IN connector
of the MD deck