Playback troubleshooting – Canon E 430 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playback
Troubleshooting
WJéfcSiJ-l
Before playback, make sure a power source is
attached to the camcorder (CA-100 with
DC-100, or battery pack).
kJ
Use the following checklist for troubleshooting when
you have problems with your camcorder.
See the instruction manual for further information.
Warnings that appear in the viewfinder:
1
. Press the
OPERATE
button to turn the
camera on.
2. Press the ^
(EJECT)
button to open the
cassette compartment.
3. Load the cassette.
4. Close the cassette compartment.
5.
Press the ■
(STOP)
button to select
playback mode.
6. Locate the playback start point using the
◄◄ (FF)
and ►►
(REW)
buttons.
7.
Press the ◄
(PLAY)
button to start playback.
If a television is connected to the camcorder, you
can also monitor playback on the television.
8.
Press the ■
(STOP)
button to end playback.
To change to record pause m ode
•
Press the •
(REC)
button.
“PAUSE” appears In the viewfinder and the
camcorder is put in record pause mode.
To end operation
•
Unload the cassette and turn the camcorder
off.
I
The battery pack
charge is low.
>
Replace it with a fully
charged battery pack.
I
A cassette has not
been loaded.
> Load a cassette.
I
The safety mechanism
is activated.
> Unload and reload the
cassette.
I
The lithium battery is
not in place properly or
the charge is low.
> Insert a new lithium
battery.
Condensation
has formed inside
the camera.
> Refer to the
instruction manual.
PUB. DIEN-099
0993AB5.14
©CANON INC. 1993
PRINTED IN JAPAN
IMPRIME AU JAPON