AVer EH1116H-4 Nano user manual - Manual (Page 14)

8
1.4 Setting Up the DVR Unit
1.4.1 Installing the Hard Disk
i
- For hard disk spec, please referring to http://surveillance.aver.com/download-center → Embedded
Hybrid DVR/NVR → EH1004H-4 Nano/EH1008H-4 Nano → Hardware Recommendations; click Search
button.
- The external USB hard disk only supports on file backup. Please do not use the external USB hard disk for
recording purpose.
The “compatible hard disks” indicated in the above recommendation list only means that these commercially
available hard disks were tested with AVer
TM
products and functioned well under normal operation conditions.
AVer
TM
does not guarantee or provide warranties, explicitly, implied or statutory with respect to the reliability of
the hard disk function or its compatibility. In no event AVer
TM
shall be liable for damages, with respect to any
business interruption of clients, lost profits, loss of programs or other data on your information handling system
or otherwise. This includes direct, indirect, incidental, special, or consequential damages, resulting from the
incompatibility caused by the usage of these hard disks, even if AVer
TM
has expressly advised about the risk of
such damages. The entire risk arising out of the use of any information attached here with is borne by the
recipient.
User can install 1 SATA hard disks inside the DVR unit.
Follow the illustrated instructions below to install the hard disk:
1. Loosen all screws(2 sides and rear side) 2. Push the cover backward and lift. The cover is a little bit
tight, please be carefully the hands.
3. Turn the cover over and place the SATA hard disk (face
down) inside the HDD holder.
4. Screw the hard disk(both side)
Place the hard disk face down and
connector interface of hard disk in this
direction.