AVer EH1116H-4 Nano user manual - Manual (Page 68)

62
- Send E-mail
Send an electronic text message. Next to the Send Email check box, click Detail.
In the E-mail Setting dialog box, click OK to exit and save the setting and Cancel to exit without saving
the setting.
(1)
(2)
(3)
(1) Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter ID and Password.
(2) Mail
Fill the mailing information.
 From: Enter the sender e-mail address.
 To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).
 Subject: Enter the message title.
 Message: Type the message.
(3) Snapshot
When send out the email, the DVR system will snapshot image of the selected camera channel.
 Select Camera: Select the channel that will be snapshot when alarm email is sending out.
 Video Size: Select the size of video that will be taken when snapshot. Auto means default size
that chosen by DVR system.
- Start Recording
Record the video from the selected camera.
1. Next to the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting.
4. In the Start Record prior text box, mark and set the
number in second for the program to begin recording
after the alarm has been trigger. The time range is
1~10 seconds.
5. In the Stop Record after text box, mark and set the