AVer EH1116H-4 Nano user manual - Manual (Page 96)

90
6.1.3.4 Network Setting
In the Network Setting dialog box, click Update to accept the new settings, click Exit to exit without saving, and
click Default to revert back to original factory setting. For the network service ports that use by DVR server,
please see Appendix A .
(1) Server Name
Assign a name for the DVR unit. Alphabet letters and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make it accessible via
internet using PCViewer, Remote Console, PDA Viewer and JavaViewer (still image). To select all the cameras,
enable the ALL check box.
(3) Network Time Synchronization
Adjust the DVR system time same as network time server. Fill in the Time Server IP address or domain name.
Select the Time Zone that DVR is located. And then, mark the Automatic Synchronize time to set automatic
synchronize time on a daily basis.
(4) Other Configuration
- Enable White List: An access permit list for the remote accessing of DVR server. Enter the IP address
and click Add. Or, enter a range of IP address and click Add. To delete the IP from the list, select the IP
and click Delete button. To reset the input, click Clear button.
i
Without any IP/IP range is assigned in White List table, none of IP address/IP range is allowed to access DVR
when White List function is enabled.