AVer EH1116H-4 Nano user manual - Manual (Page 47)

41
To setup IP camera and display current IP camera information.
Using IP Camera Motion: Enable to use the motion detection function of IP camera if the IP camera has
support motion detection and the motion recording will based on IP camera
’s motion detection setting.
IP Setting: Click IP setting to add the IP camera.
1. Click the radio button of Protocol to enable the setup of IP camera.
2. Select the Protocol, Model, Video Format, and Channel of the IP camera.
3. User also can click Auto Search button to find the IP cameras that can be detected on your LAN
network.
4. Enter IP address and connecting port in IP Camera Site column.
5. Also, user can enter URL of IP camera instead of IP address.
6. If the IP camera has authority request, please enable Authentication and enter ID and Password.
7. Click OK to connect with the IP camera.
Detail: To adjust IP camera parameters, click Detail. Click Default will back to the factory default value.
User can select Video size, Frame rate, Bitrate Mode and Quality of camera. Also, user can adjust Bright,
Contrast, Hue, Saturation, and I/O Control of the camera.
The selection and adjustment items may vary by the camera has supported.