CASO Germany MyVac 20 - Manual (Page 50)

caso Vakuumierer MyVac 20 50
15.6 Recharging of the Device:
If the engine gets slow, this means that the battery has to be
recharged; forward as follows:
1. Plug the adapter in the socket, and then put the vacuum
sealer into the charging station. The red light of the device
gets switched on.
2. As a rule it takes about 9 ~ 12 hours to fully charge the
battery (the time varies depending on the way you have used
the device).
3. Charge the battery for at least 12 hours to obtain best
performance, if you charge for the first time or haven’t used
the device for a longer time.
4. It is normal that the adapter and the charging station get
hot during the charging process.
5. In order to maintain the battery capacity, fully charge the
device every 3-6 months.
15.7 Storing your vacuum system
Keep the unit in a flat and safe place, out of the reach of
children.
Please note
► To disconnect remove the plug from the outlet.
► Always unplug this appliance from the electrical outlet
immediately after using and before cleaning.
16 Cleaning and Maintenance
This chapter provides you with important notices with regard to
cleaning and maintaining the device. Please observe the
notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
16.1 Safety information
Attention
Please observe the following safety notices, before you
commence with cleaning the device:
► The device must be cleaned and food residues must be
removed at regular intervals. If the device is not maintained
in a clean condition, this will have a detrimental effect on the
service life of the device and can also result in a dangerous