EFCO 406 (T) Series - Manual (Page 11)

TOP OF HORIZONTAL
FIG. #4
2"
TO FINISHED FLOOR
B - SHEAR BLOCKS AT SCREW
FOR TRANSOM - HEAD AND HORIZONTAL
(4) holes are located
# 26 Drill (.147 dia.),
determine the correct holes
horizontal (#8401).
to drill for the application
extrusion being used to
Refer to the horizontal
at head (#9359) or intermediate
per horizontal end.
INTERMEDIATE SHEAR BLOCK APPLICATION
block attachment holes as
pocket, then drill the shear
Insert this lug into the glazing
2) DJ16 DRILL GUIDE
F406
for left and right positions.
NOTE: The drill jig is reversible
TYPICAL VERTICAL MEMBER
2"
SECTION III FABRICATION
SPLINE DOOR JAMB
blocks.
hole pattern for the shear
drill guide to locate the
Use the top edge of the
indicated.
(CONT.)
PAGE 9
DPS 12/2002 406 STOREFRONT