EFCO 406 (T) Series - Manual (Page 32)

DOOR JAMB ASSEMBLY
SECTION IV ASSEMBLY & INSTALLATION
D - SCREW SPLINE FRAME & SIDE LITE TO
NOTE: THE SILL FLASHING ENDS AT A DOOR JAMB.
THE SILL FLASHING RUNS THRU AT JAMBS
NOTE: Use full lengths of LB78 perimeter adaptor at the head and jambs as a caulk backer
and to keep from collapsing the glazing pocket. Use 3" lengths of LB78 perimeter adaptor
(FV16) at the sill member and locate them at the fastener, to keep the anchors or weight of
the glazing material from collapsing the glazing pocket.
SILL FLASHING
AND VERTICAL INTERMEDIATES.
NOT SHOWN
#9357/#9358 SIMILAR
#8401 HORIZ. SHOWN
#9359 HEAD
#9357 SILL
#9359 JAMB
NOT SHOWN
FOR CLARITY
FIG. #34
WAX ALL SCREWS
S129
S129
ASSEMBLY SCREWS
HORIZONTALS BEFORE
THE ENDS OF ALL
APPLY SEALANT TO
ASSEMBLY.
DOOR JAMB
APPLY SEALANT TO
SNAP AREA AT THE
WAX ALL SCREWS
INTERIOR AND
EXTERIOR.
S129
S129
#9358 SHOWN at
PAGE 30
LB78/FV16 PERIMETER
FILLERS NOT SHOWN
FOR CLARITY.
(REQUIRED @ HEAD, JAMB
& SILL)