EFCO 406 (T) Series - Manual (Page 28)

WATER ONTO THE SILL FLASHING. SEE FIGURE BELOW.
WITH SEALANT LEVEL WITH THE SILL FLASHING TO DIVERT ANY
THOROUGHLY. FILL THE HOLLOW AREA OF THE DOOR JAMB
THE END OF THE SILL FLASHING TO THE DOOR JAMB
BEAD OF SEALANT THAT THE THRESHOLD IS SET INTO. SEAL
THAT FILLS THE CAVITY IN THE DOOR JAMB AND TIES INTO THE
FRAME. THE BEAD OF SEALANT WILL TIE INTO THE SEALANT
SEALANT BETWEEN THE MASONRY JAMB AND THE DOOR
INSTALL THE SILL FLASHING IN A CONTINUOUS BEAD OF
SECTION IV ASSEMBLY & INSTALLATION
C - SILL FLASHING INSTALLATION
FIG. #28
OPTIONAL SEALANT
SEAL OVER THERMAL STRUT
OF SEALANT TO THE
MASONRY JAMB
SEAL FLASHING
CONTINUOUS BEAD
APPLY SEALANT JUST
BEFORE SETTING THE
SILL MEMBER
TO JAMB
STEP 2)
Fill this cavity with
sealant, level with the
SEAL THIS AREA OF THE
sill flashing.
SILL FLASHING
(CONT.)
/200
PAGE 26