EFCO 406 (T) Series - Manual (Page 29)

INCREASE IN THICKNESS, IF THE CONDITION IN IRREGULAR.
INSTALLATION. THIS MAY CAUSE THE CAULK JOINT AT THE JAMB TO
CONCEALED WITH THE SEALANT TO PRESENT A NEAT CLEAN
AND THE PERIMETER SEALS. THE END CAP EDGES MUST ALSO BE
CONDITION AND THE SEALANT MUST TIE-IN WITH THE JAMB BLOCKING
THE SEALING PROCEDURE. THE END CAPS MUST BE SEALED TO THE
INCORPORATING THE SILL FLASHING END CAPS WILL COMPLEMENT
C - SILL FLASHING INSTALLATION
SECTION IV ASSEMBLY & INSTALLATION
The sill flashing must be sealed to the condition
and the jamb member set in a bead of sealant
to ensure a water tight seal.
OR LB78/FV16 VINYL NOT SHOWN
#9358 CONTINUOUS SHOWN
FIG. #29
VIEW OF JAMB AT CONDITION
#9357
STEP 3)
#9359
SEALANT
K980
(CONT.)
406 STOREFRONT DPS 12/2002
PAGE 27