KMC Controls REE–2004 - Manual

Installation Guide
Solid State Relay Modules
REE–2004
Mounting
•
The REE–2004 may be mounted directly to a control panel backplate surface.
•
No heat sink is required for loads up to 4 amperes. Loads greater than 4 amperes
require a heat sink and thermal pad.
KMC Controls
19476 Industrial Drive
New Paris, IN 46553
TEL: 574.831.5250
FAX: 574.831.5252
www.kmccontrols.com
Maintenance
No routine maintenance is required. Each
components design and material selection assures
long-term reliability and performance. Careful
installation and proper heat sinking will enhance
long term reliability and performance.
717-019-36
Wiring
Connect input directly to the DC output of the KMC
controller. The load may connect to either Terminal
1 or Terminal 2.
HPO-4611 Heat Sink