4 j7 terminal interface, J7 terminal interface - 12, Pinout of j7 - 12 – Kontron VMP3 User Manual
Page 46: J7 - term connector - 12, Functional description vmp3
Functional Description
VMP3
Page 2 - 12
© 2005 Kontron Modular Computers GmbH
ID 29230, Rev. 01
29230
.01.UG.VC.050727/091423
P R E L I M I N A R Y
2.4.4
J7 Terminal Interface
The VMP3 provides one serial interface for supporting a terminal port (TERM1). This interface
is realized using one of the MPC8541E on-chip UARTs, and as such provides only a two wire
interface without hardware handshake signals.
The connector J7 provides interfacing to the TERM1 port. This port can also be used as a low
speed solution for firmware updating. The signal levels on this connector are RS232 compliant.
The UART itself is a 16550 type UART.
The following figure and table provide pinout and signal information for the TERM1 interface.
Figure 2-5: J7 - TERM Connector
Table 2-8: Pinout of J7
PIN
SIGNAL
1
NC
2
GND
3
TxD1
4
RxD1
5
NC
6
NC
6
1