2 configure iol (ipmi over lan) – Kontron AM4204 User Manual
Page 33
18
www.kontron.com
• SFP module (optical or copper) for Ethernet connection to the Linux host
• ipmitool v1.8.9
3.4.3.2
Configure IOL (IPMI over LAN)
In preparation for configuring SOL, the IOL interface has to be configured first. This is done by establishing a
telnet connection via SFP1.
The interface SFP1 has a fixed configured IP address: 192.168.0.100
The Ethernet interface of the Linux host must be configured for accessing the IP address 192.168.0.100. An
IP connection from the Linux host to SFP 1 of the AM4204 must be possible.
Connect to the AM4204 via telnet
> telnet 192.168.0.100
BusyBox v1.2.1 (2008.06.05-14:58+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
~ #
Check board information (optional)
~ #
/mnt/bin/ipmitool mc info
Device ID : 6
Device Revision : 0
Firmware Revision : 5.24
IPMI Version : 1.5
Manufacturer ID : 15000
Manufacturer Name : Kontron
Product ID : 5516 (0x158c)
Device Available : yes
Provides Device SDRs : yes
Additional Device Support :
Sensor Device
FRU Inventory Device
IPMB Event Receiver
IPMB Event Generator
Chassis Device
Aux Firmware Rev Info :
0x00
0x00
0x00
0x00
~ #
Check LAN settings on the Ethernet interface to be configured for IOL (optional). At this time, this can only
be the eth0 (which is connected to AMC port 0). Default settings are shown below:
~ #
/mnt/bin/ipmitool lan print 1
Set in Progress : Set Complete
Auth Type Support : NONE PASSWORD
Auth Type Enable : Callback :
: User : NONE PASSWORD
: Operator : PASSWORD
: Admin : PASSWORD