Kontron AM4204 - Manual (Page 38)

23 AM4204
www.kontron.com
Detailed description of these options:
• -h | --help
This option shows a list of possible settings.
• -t | --status
This option shows the present configuration stored in NV ram of the MMC. This setting will take affect
after invoking a “Chassis Control Power cycle” command or after a complete hotswap cycle with remove
and reinsertion of the module.
• -I | --interface <INTF>
This option checks if the setting <INTF> is possible for this board. To set this setting the [–s|--set]
options has to be appended.
• -p | --pcie <PCIE>
This option checks if the setting <PCIE> is possible for this board. To set this setting the [–s|--set]
options has to be appended.
• -k | --clock <CLOCK>
This option checks if the setting <CLOCK> is possible for this board. To set this setting the [-s|--set]
options has to be appended
• -s | --set
This option set the configuration in the MMCs NV ram, updates the FRU data multirecord and performs a
MMC reset (IPMI Cold Reset).
• -c | --cycle
This option send the IPMI command “Chassis control Power cycle” to the MMC to perform a payload power
cycle. During the power cycle the configuration will be enabled.
This option is allowed without any other options or when a valid PCIe or Interface setting is configured
and activated with the [–s|--set] option.