Kontron OmniClient - Manual (Page 50)

OmniClient –User’s Guide (V1.02)
www.kontron.com 49
12.6. USB Port
The OmniClient contains two EHCI (Enhanced Host Controller Interface) host controllers (EHCI1 and EHCI2)
that support up to fourteen USB 2.0 ports allowing data transfers up to 480Mb/s. Legacy Keyboard/Mouse
and wakeup from sleep states are supported. Over-current detection on all fourteen USB ports is supported.
The following USB connectors are available in the IO Area.
USB Port 0 and 1 (via EHCI1) are supplied on the combined USB0, USB1 and DP0 connector.
USB Port 2 and 3 (via EHCI1) are supplied on the combined USB2, USB3 and DP1 connector.
USB Port 4 and 5 (via EHCI1) are supplied on the combined ETH1, USB4 and USB5 connector.
Note: It is required to use HiSpeed USB cable, specified in USB2.0 standard.
Table 15: USB pinout
Pin Signal Name 4-pin USB Socket
Type A Version 2.0/1.1
1 VCC
2 Data-
3 Data+
4 GND
12.7. Audio Connector
The on-board Audio circuit implements 7.1+2 Channel High Definition Audio with UAA (Universal Audio
Architecture), featuring five 24-bit stereo DACs and three 20-bit stereo ADCs. The Following Audio connector
is available in IO Area.
Audio Speakers, Line-in and Microphone are available in the stacked audiojack connector.
Table 15: Audio, Line-in, Microphone signals