Oldcastle BuildingEnvelope HP-175 - Manual (Page 30)

REF. SHEET 21 FOR
GLASS SIZING
INFORMATION AT
TYPICAL MULLION.
1 3/8"
1 3/8"
INSTALLATION NOTE:
REFERENCE SHEETS 9 FOR
ADDITIONAL DIVERTER INSTALLATION
AND SHEET 10 & 11 FOR GLAZING WITH
INTEGRAL DIVERTERS.
MARK LOCATION OF EACH
GLAZING CLIP PRIOR TO
INSTALLING FACE CAPS.
HP-36 TEMPORARY
CLIPS. SLIDE ONTO
GLAZING CLIPS.
HP-17
SETTING
BLOCK
WHEN INSTALLING FACE
CAPS USE DEADBLOW
HAMMER AND STRIKE CAPS
AT LOCATIONS OF GLAZING
CLIPS ONLY. INSTALL BACKER ROD INTO
CAVITY BEHIND GLASS AND
RUN WEATHER SEAL.
NHP-5A GASKETS.
CUT HORIZONTAL
GASKETS D.L.O.
+ 1/4" PER FOOT.
V2110 DSA TAPE
STRUCTURAL SILICONE
SEAL BETWEEN
GASKET AND TAPE
HP-10468
MULLION
HP175-FP-58 BRIDGE
MODIFY TO FIT CORNER
AND SEAL.
OUTSIDE 90° MULLION
DIVERTER & GLAZING DETAIL
H P - 1 7 5 / 2 2 5 I N S T A L L A T I O N M A N U A L
30 

