Rice Lake 480 Legend Series Digital Weight Indicator Installation Manual - Manual (Page 37)

Configuration 33
3.3.5 Digital Input Menu
Figure 3-14. Digital Input Menu
DIG IN Menu
Parameter Choices Description
DIGIN1
DIGIN2
DIGIN3
DIGIN4
OFF
Specifies the function activated by digital inputs 1, 2, 3 and 4.
Sets the Digital Input to perform no function.
ZERO Same function as the front panel key.
TARE Same function as the front panel key.
NT-GRS Net-Gross – same function as the front panel key.
UNITS Same function as the front panel key.
DSPTAR Displays the current tare value.
PRINT Same function as the front panel key.
CLRCN Resets the consecutive number to the value specified on the CONSTU parameter (PROGRM
menu).
KBDLOC Disables the keypad while the digital input is held active.
HOLD Holds the current display. Releasing this input returns to normal display update mode.
CLRTAR Clears the tare.
ACCUM Displays the accumulator.
CLRACC Clears the accumulator.
BATSTR Starts a batch process.
BATSTP Stops a batch; any restart starts the batch at the beginning.
BATRES Resets the batch process so the pointers are aimed at first batching setpoint.
BATPUS Pauses a batch, but allows it to restart at the point where it was paused.
BATRUN A switch that allows a batch to be started.It must be active to allow any batch to run.
If not active, and a BATSTRT input is activated, the batch will abort.
NET Puts the scale in NET mode.
GROSS Puts the scale in GROSS mode.
PRI Puts the scale in primary units.
SEC Puts the scale in secondary units.
Table 3-11. Digital Input Menu Parameters
CONFIG FORMAT CALIBR PROGRM DIG IN ALGOUT PASWRD TEST MENU
DIGIN1-4
OFF
ZERO
TARE
NT-GRS
UNITS
DSPTAR
PRINT
CLRCN
HOLD
KBDLOC
CLRTAR
ACCUM
CLRACC
BATSTR
BATSTP
BATRES
BATPUS
BATRUN
NET
GROSS
PRI
SEC