SINGER 7467S CONFIDENCE STYLIST - Manual (Page 14)

12
SPOOL PINS
HORIZONTAL SPOOL PIN for normal
thread spools
Place thread spool on the pin and secure with a spool cap to
ensure smooth flow of thread. If the thread spool has a thread
retaining slit, it should be placed to the right.
Select the correct spool pin cap according to the type and
diameter of spool being used. The diameter of the spool pin
cap should always be larger than that of the spool itself.
PRESSER FOOT LIFTER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric.
3. Lift it to its highest position to change the presser foot or to
remove thick fabric.
VERTICAL SPOOL PIN for large thread
spools
Attach the spool pin and place a felt disc over it. Place a spool
of thread on the spool pin.
Spool pin cap
Couvre-fil
Tapa del pasador carrete
Spool
Bobine
Carrete
Spool pin
Porte-bobine
Pasador carrete
Spool pin felt discs
Rondelle feutre
Disco del pasador carrete
Vertical spool pin
Porte-bobine vertical
Pasador de carrete vertical
Spool
Bobine
Carrete
Thread retaining slot
Fente de retenue de fil
Ranura de retención de hilo
FEED DOG CONTROL
The feed dogs control the movement of the fabric that is
being sewn. They should be raised for all general sewing
purposes and lowered for darning, freehand embroidery and
monogramming so that you, not the feed dogs, are guiding the
fabric.
How to raise the Feed Dogs:
1) Make sure that your presser foot is in the raised (up)
position, and that the needle is in the highest position.
2) With the back of the machine facing you, push the feed
dog lever down and towards the right (symbol that shows
the feed dogs above the line).
3) Turn the machine so that it now faces you, turn the
handwheel counterclockwise (towards you) until you hear
or see the feed dogs click back into place.