SINGER 14T968DC - Manual (Page 15)

14
10. PREPARATION FOR THREADING
When using synthetic threads that easily spill off
the cone, slip the anti-spill net furnished with the
machine over the thread from the bottom of the
cone leaving the thread end hanging free at the
top of the anti-spill net as shown on illustration.
Take out the thread guide from the top of
Styrofoam, and insert it as shown on illustration.
This machine is shipped with the thread guide
holder in the lowered position.
Fully extend the thread guide holder.
The two joints on the telescope will click into place
when they are correctly positioned.
Center the thread guides above the spool pins.
Place thread over the cone adapters on the spool
pins.
When using a regular thread spool, fit the spool cap
supplied with the machine onto the thread spool as
shown on illustration.
Anti-spill net
Spool cap
Press in
Thread spool
Note: Your new machine is threaded to sew
Triple Cover Stitch. Refer to Page 30 for
instructions on tying on to the threads.
Setting Up the Thread Guide Holder
Anti-spill Net
Spool Cap