SINGER 14T968DC - Manual (Page 28)

9
8
6
7
3
4
5
3
2
2
1
27
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Continue to thread points 4~8.
Pass thread from back to the front through the
thread guide 1.
Thread the top cover
thread guide by pulling
the thread towards the left
until it slips under guide.
Then pull thread along the
right side of button as
illustrated.
Before threading eye of needle, make sure thread is
in front of thread guide located on the bottom of the
needle clamp for Cover stitch and for Chain stitch.
Note: Slip thread into the middle slot of the thread
guide 5 and into the slot of take-up
lever cover 6.
Then continue by slipping thread into the
middle slot of the thread guides 7 and 8.