SINGER 14T968DC - Manual (Page 23)

9
5
8
6
7
4
3
3
2
2
1
22
Pass thread from back to the front through the
thread guide 1.
While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Continue to thread points 4~8.
Note: Slip thread into the rear slot on the thread
guide 5 and the slot of take-up lever cover 6.
Then slip thread into the right slot on the thread
guide 7, and into the right slot on the thread
guide 8.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
button as illustrated.