SINGER 14T968DC - Manual (Page 25)

4
9
9
8
7
6
5
3
3
24
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Thread the eye of the left needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
The position of the thread must be behind the
the thread guide.
Draw about 10cm (4 inches) of thread through
needle eye to hang free.
Place the thread to the back, under the presser
foot.
Continue to thread points 4~8.
Note: Slip thread into the middle slot of the thread
guide 5 and into the slot of take-up
lever cover 6.
Then continue by slipping thread into the
middle slot of the thread guides 7 and 8.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
Before threading eye of needle, make sure thread
is
located on the bottom of in front of thread guide
the needle clamp.
Note: For 4 thread overlock left needle: Use needle
A.
Note: For chain stitch :Use needle D.