SINGER 14T968DC - Manual (Page 68)

B
A
C
67
The following optional presser feet specially
prepared for this machine are available at
extra-charge.
Note: Do not use presser foot made for other
machines. Use of such presser foot may
result in interference with the needle and knife
and can be hazardous.
The snap-on type presser foot of this machine
permits easy removal and replacement.
Be sure to disconnect the power line plug or
turn off the power switch when changing the
presser foot.
Raise presser foot by lowering presser bar lifter and
raise needle bar to ist highest position.
Press red colored lever (A) located on back of clamp
under the presser foot shank, raise presser bar lifter
to its High Lift position by pressing down on the presser
bar lifter and while holding the presser bar lifter in this
position, remove the presser foot plate.
Place presser foot on needle plate under presser foot
shank so that hinge pin (C) will fit in slot (B) of the shank.
Then lower presser foot by raising presser bar lifter.
If presser foot can not be placed under presser foot
shank easily, raise presser bar by pressing down on
the presser bar lifter to its High Lift position and while
holding it in this position, place presser foot plate under
presser foot shank. Then lower presser by raising
presser bar lifter.
Raise presser bar lifter and make sure the presser
foot is properly attached to the presser foot shank.
Replacement
Snap-On Type Presser Foot
Removal
27. OPTIONAL ACCESSORIES
Caution: