SINGER 9910 Quantum - Manual (Page 24)

24
BOBBIN SETTING
A. REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and
remove the bobbin cover.
2. Lift up the bobbin from the machine.
B. SETTING SPOOL OF THREAD ON
SPOOL PIN
1. Pull up the left end of spool pin and set the
spool of thread on spool pin.
2. Set the spool cap on spool pin as far as it will
go.
a: Reverse spool cap direction according to the
size of spool.
b. Use the small spool cap when you use cross
wound thread. Leave small opening between
cap and spool as illustration.
C. WINDING THE BOBBIN
1.Hold thread in both hands and hook thread to
the guide from front opening.
2.Bring thread towards the read of the machine
and pass through the thread guide from left to
right.
3.Bring thread to the right and pass thread
through the thread guide from rear side. Pass
thread under tension disc in counter clockwise
direction.
4.Insert thread through hole in bobbin and place
the bobbin on bobbin winder spindle. Push
bobbin to the right to engage bobbin winder.
5.Hold the end of the thread and start the
machine by pressing foot controller pedal.
6.After the bobbin winds a few turns, stop the
machine and cut the thread near hole.
7.Start the machine again.
8.The bobbin winding will stop when bobbin is
full. Then release the pedal.
9.Push the bobbin and spindle to the left.
10.Remove the bobbin from the spindle and cut
the thread.
2003.9.10, 8:46 PM 24