SINGER SEQS-6700 FUTURA QUARTET Instruction Manual - Manual (Page 10)

8
USING AUTOMATIC NEEDLE THREADER
¹ Be sure to raise the presser foot lifter and raise the needle
to its highest position before threading.
IMPORTANT: If the needle cannot be threaded with the
Automatic Needle Threader due to particular qualities
of the thread, or if the thread is too thick for the
needle being used, then manually thread the needle
after hooking the thread through the thread guide on
the needle bar.
NOTE:
º For smooth threading, it is recommended that the
machine be set for straight stitch (in center needle
position) when using the automatic needle threader.
º +HDY\ WKUHDG FDQQRW EH WKUHDGHG WKURXJK ¿QH QHHGOH
º Don’t lower the threading lever while the machine is
in operation or the threading hook may be broken.
1. Thread the machine with your left hand while gripping the
thread with your right hand. Hook thread to the thread
guide on the needle bar and pull it toward you leaving
about 4” (10 cm) clear.
2. Hook thread into the twin thread guides (A and B).
3. Pull thread gently into the thread cutter/holder to cut and
hold it in place.
4. Pull down the threading lever to its lowest position until the
twin thread guide rotates and stops.
5. Release the threading lever and needle will be threaded
automatically. If it should not return to the original position,
raise it gently by hand.
6. Pull thread loop away from you.
Don’t pull thread with strong force or thread may
be pulled off from needle hole after threading.
Make sure that the guide doesn’t touch fabric, etc.
If the needle has not been threaded correctly, re-
thread from STEP 1.
1
Threading hook
Thread guide
3
Thread cutter/holder
2
Twin thread guide
B
A
4
Threading lever
5 6