SINGER SEQS-6700 FUTURA QUARTET Instruction Manual - Manual (Page 13)

11
1
3
2
Under side
Top side
Well balanced
Decrease tension Increase tension
Top stitch too loose Top stitch too tight
Presser foot lifter
Foot holder
Foot release button
CHANGING PRESSER FOOT
Be sure the needle is in the highest position. Raise presser
foot lifter.
1. Push presser foot release button to remove the foot.
2. Place the desired foot on the needle plate aligning the
presser foot pin with the foot holder.
3. Lower the presser foot lifter so that the foot holder snaps
on the foot.
ADJUSTING TOP THREAD TENSION
STRAIGHT STITCHING
The correct appearance of your stitching is largely determined
by the balanced tension of both top and bobbin threads. The
tension is well balanced when these two threads ‘lock’ in the
middle of layers of the fabric you are sewing.
,I ZKHQ \RX VWDUW WR VHZ \RX ¿QG WKDW WKH VWLWFKLQJ LV LUUHJXODU
you will need to adjust the tension control. Do this, however,
only after you have determined that the machine is correctly
threaded (see page 7).
Make all adjustments with presser foot ‘down’.
A balanced tension (identical stitches both top and bottom) is
usually only desirable for straight stitch sewing.
ZIGZAG, SATIN STITCH, DECORATIVE and
BUTTON HOLE SEWING
For zigzag sewing, satin stitch and decorative stitch functions,
thread tension should be less than that for straight stitch
sewing.
It is recommended to decrease thread tension for buttonholes.
You will always obtain a nicer stitch and less puckering when
the upper thread appears slightly on the bottom side of your
fabric.
BOBBIN TENSION
The bobbin tension has been correctly set at the factory,
so you do not need to adjust it.
Helpful Hint: A slight adjustment to a higher number or a
lower number may improve sewing appearance.